3D model description
Christmas Baubles in different designs:
Two ropes – single color
Two ropes – dual color
Four ropes – single color (only the rope, if your printer is able to print it without the sphere inside)
Four ropes – dual color
Ten ropes – single color (only the rope, if your printer is able to print it without the sphere inside)
Ten ropes – dual color
I´ve printed the Two ropes – single color version with 3 perimeter, 0.2mm layer height and 20% lightning infill.
The filament is Prusament PLA Blend Viva La Bronze and i printed it on my CR10-V2 with 215° nozzle and 50° bed temperature.
I used tree supports at angle higher then 60 degree.
You will need some supports because of the rope geometry which creates a lot of overhangs.
I have only a single color printer, so hopefully someone with a multi color will share a make of the dual color versions.
Would be happy to see your makes!
3D printing settings
Slicer software: Cura 5.6
Printer: CR10-V2
Filaments: Prusament PLA Blend Viva La Bronze, but others will also work
Infill: 20% Lightning, two lines and connected
Retraction: 2mm
Nozzle Temp: 215°
Bed Temp: 50°
Print Speed: 80mm/s inside / 40mm/s outside
Support: Tree supports 60 degree
